Loading...

For 30 years, we have been using all our skills and expertise in the manufacturing of medical consumables.

We have two manufacturing sites (Sidi Maarouf and Laasillat) with advanced technology facilities for the manufacturing and sterilization of our products, as well as a storing unit (a covered area of 10 000m²).

The environment in our facilities is subject to regular inspections in order to maintain good hygiene and a regulatory level of bioburden and airborne contamination.

The rigour and meticulousness control of our facilities is based on the GMP and ISO rules.

As for our sterilization process, it has been approved by a team of professionals and was submitted to inspection at regular intervals in accordance with the regulatory rules in force.

SIDI MAAROUF (CASABLANCA) FACTORY

This site is dedicated to the manufacturing resorbable and non-resorbable sutures, catheters and surgical drains.

  • Absorbable sutures are made of synthetic polymers and are available in monofilament (STERIXON) or multifilament braided (STERIXYL, STERIXYL II).
  • Non-Absorbable sutures are available in monofilament (STERICRIN, STERIPRO, SUPRALENE), twisted (STERILIN) and braided (STERISILK, STERIDEK).
  • Surface area : 1 000 m²
  • Manufacturing in clean room (class 100 000 – ISO 8) with the following characteristics :
    • HVAC system
    • HEPA air filtration
    • Maintenance of positive pressure
    • Controlled temperature
    • Regulated humidity
  • Cold room
  • An ethylene oxide sterilizer complying with the EN 550 Standard
  • A Testing laboratory: We have a highly qualified staff and high-performance equipment for bacteriological and physio-chemical testing
  • A storing warehouse

LAASILAT Factory (REGION of greater casablanca)

This site is dedicated to the manufacturing sterile swabs, eyes pads, gauze, jersey bandages, and adhesive strips (adhesive tapes).

Our swabs are cut, sterilized and ready-for-use immediately after their release out of the factory. We make them out of natural fibers of 100% absorbent cotton gauze. Thus, they are very absorbent and well tolerated.

  • Surface area: 2 500 m²
  • The manufacturing takes place in clean room (joint development zone)with the following characteristics :
    • HVAC system
    • HEPA air filtration
    • Maintenance of positive pressure
    • Controlled temperature
    • Regulated humidity
  • A modern and full machinery carries out all the manufacturing steps (Weaving, Cutting, Packing and Sterilizing)
  • An appropriate labelling system on different packages
  • A sterilizer complying with the standards;
  • A Testing laboratory for bacteriological and physio-chemical testing
  • A storing warehouse